Volvo XC60: Reinserting the headlight housing
When reinserting the housing, be sure that the long locking pin (to the left in the illustration) is securely in place in both of its retaining clamps.
1. Plug in the connector until it clicks into place.
2. Reinstall the headlight housing and locking pins. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot.
3. Check that the lights function properly.
The headlight wiring must be connected and the housing must be securely in place before the ignition is switched on.
Removing the headlight housing
1. Switch off the ignition by briefly pressing
the START/STOP ENGINE button.
2. Remove the remote key from the ignition
slot1.
3. (Upper illustration under "Headlight housing").
&nb ...
Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see
page 322.
1. Open the retaining clamps by pressing
them to the sides.
2. Pull the cover straight out.
Reinstall the cover in the reverse order. ...
See also:
Important safety notes
WARNING
Air bags are designed to reduce the incidence of injuries and fatalities in certain
situations:
frontal impacts (driver's and frontpassenger front air bags and driver's
...
Cleaning Exterior Lamps/ Lenses and Emblems
Use only lukewarm or cold water, a soft cloth, and a car washing soap to clean
exterior lamps and lenses. Follow instructions under "Washing the Vehicle" later
in this section. ...
Headlight Aiming
The headlights were properly aimed
when your vehicle was new. If you
regularly carry heavy items in the
cargo area or pull a trailer,
readjustment may be required.
Adjustments should be done ...
