Subaru Forester: Rear wiper
To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the “INT” or “ON” position.
To turn the wiper off, return the knob on the end of the lever to the “OFF” position.
With the switch turned to the “INT” position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed (longer when the vehicle speed is low; shorter when the vehicle speed is high).
When the transmission is shifted into reverse, the rear wiper will switch to continuous operation. When the transmission is shifted to a position other than reverse, the rear wiper will return to intermittent operation.
Rear window wiper and washer switch
Rear window wiper and washer switch
Washer (accompanied by wiper
operation)
ON: Continuous
INT: Intermittent
OFF: Off
Washer ...
Washer
To wash the rear window while the rear
wiper is operating, turn the knob clockwise
to the “” position. The washer fluid
sprays until you release the knob.
To wash the rear window when the r ...
See also:
Searching for and storing songs
The Song Seek function provides notification
when Sirius is broadcasting the songs selected
in song memory. Song memory enables you
to store the name of the song for future
advance notificatio ...
Instrument Panel Illumination Control
This control is located on the instrument panel, to the left of the steering
column.
(Instrument Panel Brightness): Turn
clockwise or counterclockwise to brighten or dim the lights. ...
Ignition mode II
- With the remote key fully pressed into the
ignition slot, press START/STOP
ENGINE for approximately 2 seconds. ...
