Subaru Forester: Rear seatbelts (except rear center seatbelt) - Fastening the seatbelt - Seatbelts - Seat, seatbelt and SRS airbags - Subaru Forester Owner's ManualSubaru Forester: Rear seatbelts (except rear center seatbelt)

1. Sit well back in the seat.

2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly after giving a strong pull on it, then pull it out slowly again.

3. Insert the tongue plate into the buckle

3. Insert the tongue plate into the buckle until you hear a click.

4. To make the lap part tight, pull up on

4. To make the lap part tight, pull up on the shoulder belt.

5. Place the lap belt as low as possible on your hips, not on your waist.

    Unfastening the seatbelt
    Unfastening the seatbelt Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...

    Unfastening the seatbelt
    Unfastening the seatbelt Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...

    See also:

    Window washer fluid
    Type A Type B Fill the window washer fluid reservoir periodically. Add window washer fluid when the low window washer fluid warning light illuminates (if so equipped). To fill the window w ...

    Draining of coolant water
    If the vehicle is to be left outside without antifreeze, drain the cooling system, including the engine block. Refill before operating the vehicle. For details, see “Engine cooling system” in ...

    StabiliTrak® OFF Light
    This light comes on when the StabiliTrak system is turned off. If the Traction Control System (TCS) is off, wheel spin is not limited. If the StabiliTrak system is off, the system does not assis ...