Jeep Liberty: Call Termination - Phone Call Features - Uconnect™ Phone — If Equipped - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Call Termination

To end a call in progress, momentarily press the button. Only the active call(s) will be terminated and if button. Only the active call(s) will be terminated and if there is a call on hold, it will become the new active call.

If the active call is terminated by the phone far end, a call on hold may not become active automatically. This is cell phone-dependent. To bring the call back from hold, press and hold the a single beep. button until you hear a single beep.

    Three-Way Calling
    To initiate three-way calling, press the button while a call is in progress, and make a second phone call, as described under “Making a Second Call While Current Call is in Progress”. Afte ...

    Redial
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Redial”. • The Uconnect™ Phone will call the last number that was dialed from your mobile ph ...

    See also:

    Buttons in the center console
    ...

    Taking out the spare wheel
    1. Open the floor hatch. 2. Undo the retaining bolt. 3. Lift out the foam block. 4. Lift out the spare wheel. The other two blocks can remain in the spare wheel well. After use The foam block ...

    Multi-function light switch
    COMBINATION TURN SIGNAL, HEADLIGHT AND HIGH-BEAM SWITCH Turn Signal Operation Pulling down on the lever causes the turn signals on the left side of the car to blink. Pushing upwards on the lever ...