Mitsubishi Outlander: Parking brake break-in
Break-in the parking brake linings whenever the brake performance of the parking brake is insufficient or whenever the parking brake linings and/or discs are replaced, in order to assure the best brake perfomance. This procedure is described in the vehicle service manual and can be carried out by a MITSUBISHI MOTORS Authorised Service Point.
Tyres
WARNING:
● Driving with tyres that are worn or improperly inflated can result in a collision
and serious or fatal injury.
Tyre inflation pressures
*: Above 160 km/h (100 mph).
Check the ...
Wiper blade rubber replacement
Windscreen wiper blades
1. Lift the wiper arm off the windscreen. 2. Pull the wiper blade until its stopper
(A) disengages from the hook (B). Pull the wiper blade further to remove it.
NOTE:
& ...
See also:
Using traction devices
Only use traction devices in
heavy
snow conditions, on hard road
surfaces.
Dynamic Stability Control (DSC) must
be switched off when using traction
devices.
Never exceed 50 km/h (30 mph) when ...
Front-side view
Front-side view
Guiding lines:
Guiding lines that indicate the width and the
front end of the vehicle are displayed on the
monitor.
The front-of-vehicle line 1 shows the front part
of the v ...
Traction
The traction grades, from highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specified gov ...
