Mercedes-Benz GLK-Class: Opening/closing the garage door
Once programmed, the integrated remote control will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
X Turn the SmartKey to position 2 in the ignition lock.
X Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door. Garage door system with fixed code: indicator lamp 1 lights up continuously.
Garage door system with rolling code: indicator lamp 1 flashes briefly and then lights up for approximately two seconds. This is repeated for up to 20 seconds.
The transmitter will transmit a signal for as long as the transmitter button
is being pressed. The transmission will be halted after a maximum of 20 seconds
and indicator lamp 1 will flash. Press the transmitter button again, if necessary.
Programming the integrated garage door opener on the rear-view mirror
Programming
WARNING
Only press the transmitter button on the integrated remote control if there are
no persons or objects present within the sweep of the garage door. People could
otherwise ...
Clearing the memory of the integrated garage door opener on the rear-view mirror
X Turn the SmartKey to position 2 in the ignition lock.
X Press and hold transmitter buttons 2 and 4 for approximately 20 seconds until
indicator lamp 1 flashes rapidly. The memory is cleared.
...
See also:
Blocking wheels
Place suitable blocks 1 at both the front and
back of the wheel diagonally opposite the flat
tire to prevent the vehicle from moving when it is
jacked up.
Be sure to block the wheel as th ...
Manual command selection
Commands can be selected manually. While the
commands are displayed on the audio screen,
select a command by operating the audio tuning
switch, and then push the switch.
Once a
command is m ...
Important safety notes
The HomeLinkВ® garage door opener integrated in the rear-view mirror allows you
to operate up to three different door and gate systems.
Certain garage door drives are incompatible with the integ ...
