Mercedes-Benz GLK-Class: Opening and closing the side windows
- Front left
- Front right
- ear right
- ear left
The switches for all side windows are located on the driver's door. There is also a switch on each door for the corresponding side window. The switches on the driver's door take precedence.
The side windows cannot be operated from the rear when the override feature for the side windows is activated ().
- Turn the SmartKey to position 1 or 2 in the ignition lock.
- To open: press the corresponding switch.
- To close: pull the corresponding switch.
If you press the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.
You can continue to operate the side windows after you switch off the engine or remove the SmartKey. This function is available for up to five minutes or until the driver's or front-passenger door is opened.
Important safety notes
WARNING When opening or closing the door windows, make sure there is no danger of anyone being harmed by the opening/closing procedure. The door windows are equipped with the express operatio ...Convenience opening feature
You can ventilate the vehicle before you start driving. To do this, the key is used to carry out the following functions simultaneously: unlock the vehicle open the side windows open the pan ...See also:
List of voice commands
When you push and release the
button on
the steering wheel, you can choose from the
commands on the Main Menu. The following
pages describe these commands and the
commands in each sub-men ...
Towing a Disabled Vehicle
Emergency Towing
If your vehicle is disabled, it may be towed by a tow truck using one of the
following methods: 1) Tow the vehicle with two wheels lifted by the tow truck and
the other two wheel ...
Setting a warning distance
This setting determines the distance at which
the visual and audible warnings are triggered.
Select Long, Normal or Short by pressing MY
CAR on the center console control panel and
going to Set ...