Mercedes-Benz GLK-Class: Low-beam headlamps (halogen headlamps)
- Switch off the lights.
- Open the hood.
- Remove the headlamp cover ().
- Left-hand headlamp: detach the washer fluid reservoir ().
- Turn housing cover 1 counter-clockwise and pull it out.
- Pull connector 2 from bulb 4.
- Unclip retaining spring 3 and fold it down.
- Pull out bulb 4.
- Insert the new bulb.
- Clip retaining spring 3 back in.
- Attach connector 2 to bulb 4.
- Attach housing cover 1 and turn it clockwise until it engages.
- Left-hand headlamp: fasten the washer fluid reservoir ().
- Install the headlamp cover ().
Removing/attaching the washer fluid reservoir
You must remove the washer fluid reservoir from the engine compartment before you can replace the bulbs in the left-hand headlamp. To detach: turn catch 2 counterclockwise. Swing washer flui ...High-beam headlamps (halogen headlamps)
Switch off the lights. Open the hood. Remove the headlamp cover (). Left-hand headlamp: detach the washer fluid reservoir (). Turn housing cover 1 counter-clockwise and pull it out. Pre ...See also:
Type B audio set (if equipped)
Type B audio set (if equipped)
The audio set will operate only when the
ignition switch is in the “Acc” or “ON”
position.
- Power and audio controls: refer to page
- Radio operation: ...
Programming The Memory Feature
To create a new memory profile, perform the following:
NOTE: Saving a new memory profile will erase an
existing profile from memory.
1. Turn the ignition ON.
2. Adjust all memory profile settings ...
Automatic transaxle
Checking the automatic transaxle fluid level The automatic transaxle fluid level
should be checked regularly. Keep the vehicle on the level ground with the parking
brake applied and check the fl ...