Ford Escape: Jump starting
1. Start the engine of the booster vehicle and run the engine at
moderately increased speed.
2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Connecting the jumper cables
Note: In the illustration, the vehicle on the bottom is used to designate
the assisting (boosting) battery.
1. Connect the positive (+) jumper
cable to the positive (+) terminal of
the discharge ...
Removing the jumper cables
Remove the jumper cables in the reverse order that they were
connected.
Note: In the illustration, the vehicle on the bottom is used to designate
the assisting (boosting) battery.
1. Remove th ...
See also:
Windows
Press the front of the switch to lower the window. Pull the switch up to raise
it.
Pushing or pulling the switch part of the way will open or close the window as
long as the switch is operated. ...
Removing/attaching the washer fluid reservoir
You must remove the washer fluid reservoir from the engine compartment before
you can replace the bulbs in the left-hand headlamp.
To detach: turn catch 2 counterclockwise.
Swing washer flui ...
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The “Oil Change Required” message
will flash in the EVIC display for approximately 10 seconds
after a single chime has so ...
