Volvo XC60: Introduction - Replacing bulbs - Maintenance and specifications - Volvo XC60 Owner's ManualVolvo XC60: Introduction

All bulb specifications are listed on page 328.

The following bulbs should only be replaced by a trained and qualified Volvo service technician:
• Dome lighting, reading lights
• Glove compartment lighting
• Footwell lighting
• Turn signals in the door mirrors
• Approach lighting in the door mirrors
• Brake lights/rear fog light/taillights
• Rear parking lights
• Active Bending Lights
• LED bulbs

See page 328 for a list of bulb specifications.

NOTE
For information regarding any other bulbs not mentioned in this section, please contact your Volvo retailer or a trained and authorized Volvo service technician.

WARNING
• The engine should not be running when changing bulbs.
• If the engine has been running just prior to replacing bulbs in the headlight housing, please keep in mind that components in the engine compartment will be hot.

WARNING
• Active Bending Lights* – due to the high voltage used by these headlights, these bulbs should only be replaced by a trained and qualified Volvo service technician.
• Turn off the lights and remove the remote key from the ignition before changing any bulbs.

    Headlight housing
    The entire headlight housing must be lifted out when replacing all front bulbs. CAUTION Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the he ...

    See also:

    Channel scan
    Press the “SCAN” button briefly (type A, B and C audio)/for more than 1.5 seconds (type D audio) to change the radio to the SCAN mode. In this mode, under the selected category, the radi ...

    Anti-entrapment function
    When the moonroof senses a substantial enough object trapped between its glass and the vehicle’s roof during closure, it automatically moves back by 6 in (15 cm) from that point and then sto ...

    Checking engine coolant level
    Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level 2 , open the reservoir cap and add coolant up to the MAX level 1 . If the reserv ...