Toyota RAV4: Installing towing eyelet - If your vehicle needs to be towed - Essential information - When trouble arises - Toyota RAV4 Owner's ManualToyota RAV4: Installing towing eyelet

Remove the eyelet cover using a

Remove the eyelet cover using a flathead screwdriver. To protect the bodywork, place a rag between the screwdriver and the vehicle body, as shown in the illustration.

Insert the towing eyelet into the

Insert the towing eyelet into the hole and tighten partially by hand.

Tighten down the towing eyelet

Tighten down the towing eyelet securely using a wheel nut wrench.

    Emergency towing
    If a tow truck is not available, in an emergency your vehicle may be temporarily towed using a cable or chain secured to the emergency towing eyelet. This should only be attempted on hard surfaced r ...

    Towing with a sling-type truck
    Do not tow with a sling-type truck to prevent body damage. ...

    See also:

    SmartKey
    Display messages Possible causes/consequences and Solutions Key Does Not Belong to Vehicle You have put the wrong SmartKey in the ignition lock. Use the correct Smart ...

    To Exit Remote Start Mode Without Driving The Vehicle
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...

    Replacing a Front Turn Signal Light Bulb
    1. Open the hood. To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder. 2. Remove the socket from the headlight a ...