Subaru Forester: Initialization of power window (type A)
If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the following functions are deactivated.
- One-touch auto up/down function
- Anti-entrapment function
Initialize the power window using the following procedure to reactivate these functions.
1. Close the driver’s door.
2. Turn the ignition switch to the “ON” position.
3. Open the driver’s side window halfway by pushing down the power window switch.
4. Pull up the power window switch and close the window completely. Continue pulling up the switch for approximately 1 second after the window is closed completely.
Power window operation by passengers
Each passenger window can be controlled by the power window switch located on the door. To open: Push the switch down and hold it until the window reaches the desired position. To close: P ...Rear gate
The rear gate can be locked and unlocked using any of the following systems. - Power door locking switch: Refer to “Power door locking switches”. - Remote keyless entry system: Refer to ...See also:
Engine Oil Pressure Light
WARNING
Do not keep driving if the oil pressure is low. The engine can become so hot
that it catches fire. Someone could be burned. Check the oil as soon as possible
and have the vehicle serviced ...
Reinserting the key blade in the remote key
1. Hold the remote key with the slot for the
key blade up.
2. Carefully slide the key blade into its groove.
3. Gently press the key blade in the groove
until it clicks into place. ...
Opening and closing
Overhead control panel
To open
To open
To close
Turn the SmartKey to position 1 or 2 in the ignition lock.
Press or pull the switch
in the corresponding direction.
If you press ...