Mercedes-Benz GLK-Class: Important safety notes
The fuses in your vehicle serve to close down faulty circuits. If a fuse blows, all the components on the circuit and their functions stop operating.
WARNING
Only use fuses approved by Mercedes-Benz with the specified amperage for the system in question and do not attempt to repair or bridge a blown fuse. Using other than approved fuses or using repaired or bridged fuses may cause an overload leading to a fire, and/or cause damage to electrical components and/or systems. Have the cause determined and remedied by an authorized Mercedes-Benz Center.
Blown fuses must be replaced with fuses of the same rating, which you can recognize by the color and value. The fuse ratings are listed in the fuse allocation chart. An authorized Mercedes-Benz Center will be happy to advise you.
If a fuse has blown, contact a breakdown service or an authorized Mercedes-Benz Center.
If the newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
Only use fuses that have been approved for Mercedes-Benz vehicles and which have the correct fuse rating for the system concerned. Otherwise, components or systems could be damaged.
Fuses
...Before changing a fuse
Park the vehicle and apply the parking brake. Switch off all electrical consumers. Remove the SmartKey from the ignition lock. The fuses are located in various fuse boxes: fuse box on th ...See also:
Cellular and GPS Antennas
Avoid placing items over or near the antenna to prevent blocking cellular and
GPS signal reception. Cellular reception is required for OnStar to send remote signals
to the vehicle. ...
Child restraint systems
A child restraint system for a small child or baby must itself be properly
restrained on the seat with the lap portion of the lap/shoulder
belt.
The laws of all 50 states of the U.S.A. and Canada n ...
Ignition mode I
NOTE
To access ignition modes I or II without starting
the engine, the brake pedal must not be
depressed.
- With the remote key fully pressed into the
ignition slot, press START/STOP
ENGINE ...