Subaru Forester: How to preset channels - Channel preset - Satellite radio operation (if equipped) - Audio - Subaru Forester Owner's ManualSubaru Forester: How to preset channels

1. Press the “SAT” button to select SAT1, SAT2 or SAT3 reception.

2. Select the desired channel.

3. Press one of the preset buttons (from to to to store the channel. If the button is) for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory.

NOTE
- Up to six SAT1, SAT2 and SAT3 channels each may be preset.

- If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons.

    Selecting preset channels
    1. Press the “SAT” button to select SAT1, SAT2 or SAT3 reception. 2. Press the preferred preset button briefly. ...

    See also:

    Pulling a Trailer
    Here are some important points: ○ There are many laws, including speed limit restrictions that apply to trailering. Check for legal requirements with state or provincial police. ○ Do n ...

    Flash-To-Pass
    You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...

    Fog Lamps
    The fog lamps control is located on the turn/lane change lever. Use the fog lamps for better vision in foggy or misty conditions. FOG (Fog Lamps): Turn the fog lamp band on the lever to and re ...