Jeep Liberty: High/Low Beam Switch - Lights - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: High/Low Beam Switch

Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam.

    Turn Signals
    Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. Turn Signal Control NOTE: ...

    Flash-To-Pass
    You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...

    See also:

    Reclining Seatbacks
    Manual Reclining Seatbacks To recline a manual seatback: 1. Lift the lever. 2. Move the seatback to the desired position, and then release the lever to lock the seatback in place. 3. Push and ...

    When the System Does Not Seem To Work Properly
    The RVC system may not work properly or display a clear image if: ○ The RVC is turned off. See “Turning the Rear Vision Camera System On or Off” earlier in this section. ○ It is da ...

    Using KEYLESS-GO to start the engine
    WARNING As long as the SmartKey is in your vehicle, the vehicle can be started. Therefore, never leave children unattended in the vehicle, as they could otherwise accidentally start the engi ...