Volvo XC60: High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward
the
steering wheel to position 2 to toggle
between high and low beams (this also
applies on models equipped with the
optional Active Bending Lights).
> The symbol illuminates in the
instrument panel to indicate that the
high beams are on.
High beam flash
Move the lever toward the steering wheel to
position 1. The high beams come on until the
lever is released. ...
Low beams
When the engine is started, the low beams are
activated automatically (daytime running lights)
if the headlight control is in position 0 or
.
Daytime running lights can be deactivated in
the ...
See also:
Windshield Wiper and Washer Lever
Windshield Wipers
To turn the windshield wipers on, move the lever up and down to one of the four
operating positions. In the “INT” position (if equipped), the wipers operate intermittently.
...
When to Add Engine Oil
2.4L L4 Engine
3.0L V6 Engine
If the oil is below the cross-hatched area at the tip of the dipstick, add 1
L (1 qt) of the recommended oil and then recheck the level. See “Selecting the Righ ...
Important Safety Precautions
You’ll find many safety
recommendations throughout this
section, and throughout this manual.
The recommendations on this page
are the ones we consider to be the
most important. ...
