Toyota RAV4: Head restraints
Head restraints are provided for all seats.
Front seats
1 Up
Pull the head restraints up.
2 Down
Push the head restraint down
while pushing the lock release
button.
Second seats
1 Up
Pull the head restraints up.
2 Down
Push the head restraint down
while pushing the lock release
button.
Third seats (if equipped)
1 Up
Pull the head restraints up.
2 Down
Push the head restraint down
while pushing the lock release
button.
■Removing the head restraints
Front seats
Pull the head restraint up while pushing the lock release button.
Second seats
Pull the head restraint up while pushing the lock release button.
Third seats (if equipped)
Pull the head restraint up while pushing the lock release button.
■Installing the head restraints
Front seats
Align the head restraint with the installation holes and push it down while pressing the lock release button.
Second seats
Align the head restraint with the installation holes and push it down while pressing the lock release button.
Third seats (if equipped)
Align the head restraint with the installation holes and push it down while pressing the lock release button.
■Adjusting the height of the head restraints
Make sure that the head restraints are adjusted so that the center of the head restraint is closest to the top of your ears.
■Adjusting the rear seat head restraints (except second outside head restraints)
Always raise the head restraint one level from the stowed position when using.
CAUTION
■Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to
do so may result in death or serious injury.
●Use the head restraints designed for each respective seat.
●Adjust the head restraints to the correct position at all times.
●After adjusting the head restraints, push down on them and make sure
they are locked in position.
●Do not drive with the head restraints removed.
Stowing third seats (vehicles with third seats)
■ Before stowing the third seats Stow the third seat belt buckles. Pass the seat belts through the seat belt hangers. This prevents the shoulder belt from being damaged. 3 Lower the he ...Seat belts
Make sure that all occupants are wearing their seat belts before driving the vehicle. ■ Correct use of the seat belts ● Extend the shoulder belt so that it comes fully over the shou ...See also:
Checking the coolant level
Checking the coolant level
1) “FULL” level mark
2) “LOW” level mark
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside
of the reservoir while the eng ...
Engine Speed Limiter
If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused ...
Outside mirrors
Outside mirrors ...