Nissan Rogue: Hazard warning flasher switch
Hazard warning flasher switch
Push the switch on to warn other drivers when you must stop or park under emergency conditions.
All turn signal lights will flash.
- If stopping for an emergency, be sure to move the vehicle well off the road.
- Do not use the hazard warning flashers while moving on the highway unless unusual circumstances force you to drive so slowly that your vehicle might become a hazard to other traffic.
- Turn signals do not work when the hazard warning flasher lights are on.
The flasher can be actuated with the ignition switch in any position.
Some state laws may prohibit the use of the hazard warning flasher switch while driving.
Fog light switch (if so equipped)
To turn the fog lights on, turn the headlight switch to the position, then turn the switch to the position. To turn them off, turn the switch to the OFF position. The headlights must be ...Horn
Horn To sound the horn, push the center pad area of the steering wheel. Do not disassemble the horn. Doing so could affect proper operation of the supplemental front air bag system. Tam ...See also:
Operating the HomeLink® Universal Transceiver
HomeLink Universal Transceiver (once programmed)
may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink® Universal
Transceiver button. T ...
Gear Oil
Specified Gear Oil
When replacing gear oil, use gear oil with the appropriate viscosity and grade
as shown in the charts below. We highly recommend you use SAE 75W-90 gear oil (SAE
80W-90 for fro ...
DOOR position
When the switch is in the DOOR position 2 ,
the ceiling light will illuminate under the following
conditions:
- ignition switch is turned to the LOCK
position
— remain on for about 15 seco ...