Dodge Nitro: Hazard warning flasher
The Hazard Warning Flasher switch is located on the lower switch bank below the climate controls.
Press the switch to turn on the
Hazard Warning
flasher. When the switch is activated, all directional
turn signals will flash on and off to warn oncoming
traffic of an emergency. Press the switch a second time to
turn off the Hazard Warning flasher.
This is an emergency warning system and should not be
used when the vehicle is in motion. Use it when your
vehicle is disabled and is creating a safety hazard for
other motorists.
If it is necessary to leave the vehicle to go for service, the
HazardWarning flasher will continue to operate with the
ignition key removed and the vehicle locked.
NOTE: With extended use, the Hazard Warning flasher may wear down your battery.
If your engine overheats
In any of the following situations, you can reduce the
potential for overheating your engine by taking the
appropriate action.
• On the highways — slow down.
• In city traffic — while ...
See also:
Maximum load rating
The load rating at the maximum
permissible weight load for this tire.
For example, “MAX. LOAD 580 kg
(1279 LBS) @ 300 kPa (44 PSI)
MAX. PRESS.”
Maximum load rating applies
only to th ...
Using Voice Commands During a Planned Route
Cancel Route
1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.”
System responds: “Would you like to cancel route directions to your destination?”
2. Say “Ye ...
Cellular Phone Usage
Cellular phone usage can cause interference with the vehicle's radio. ...
