Jeep Liberty: General Information
This device complies with FCC rules Part 15 and Industry Canada RSS-210. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be received including interference that may cause undesired operation.
NOTE:
• The transmitter has been tested and it complies with
FCC and IC rules. Changes or modifications not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the
device.
• The term IC before the certification/registration number only signifies that Industry Canada technical specifications were met.
Troubleshooting Tips
If you are having trouble programming HomeLink , here
are some of the most common solutions:
• Replace the battery in the original hand-held transmitter.
• Press the LEARN button on the Garage ...
Power Sunroof — If Equipped
The power sunroof switch is located between the sun
visors on the overhead console.
Power Sunroof Switch
WARNING!
• Never leave unattended children in a vehicle with
the key in the ignitio ...
See also:
Reporting safety defects
For USA
If you believe that your vehicle has a defect
which could cause a crash or could cause
injury or death, you should immediately
inform the National Highway Traffic Safety
Administratio ...
Headlight aiming control (if so equipped)
Headlight aiming control (if so equipped)
Depending on the number of occupants in the
vehicle and the load it is carrying, the headlight
axis may be higher than desired. If the vehicle is
tra ...
VSA OFF Switch
This switch is under the driver’s side
vent. To turn the VSA system on and
off, press and hold it until you hear a
beep.
When VSA is off, the VSA off
indicator comes on as a reminder.
Pr ...