Nissan Rogue: Fuses

Nissan Rogue / Nissan Rogue 2nd Gen Owner's Manual / Maintenance and do-it-yourself / Fuses

Engine compartment

Never use a fuse of a higher or lower

Never use a fuse of a higher or lower amperage rating than that specified on the fuse box cover. This could damage the electrical system or cause a fire.

If any electrical equipment does not operate, check for an open fuse.

1. Be sure the ignition switch and the headlight switch are turned off.

2. Open the engine hood.

3. Remove the air cleaner duct. (See “Engine compartment check locations” earlier in this section.) 4. Remove the fuse/fusible link holder cover using a suitable tool 1 and pushing the tab 2 .

5. Remove the fuse with the fuse puller located in the passenger compartment fuse box.

6. If the fuse is open A , replace it with a new

6. If the fuse is open A , replace it with a new fuse B .

7. If a new fuse also opens, have the electrical system checked and repaired by a NISSAN dealer.

Fusible links

If any electrical equipment does not operate and fuses are in good condition, check the fusible links. If any of these fusible links are melted, replace only with genuine NISSAN parts.

Passenger compartment

Never use a fuse of a higher or lower amperage rating than that specified on the fuse box cover. This could damage the electrical system or cause a fire.

If any electrical equipment does not operate, check for an open fuse.

1. Be sure the ignition switch and the headlight switch are turned off.

2. Pull to remove the fuse box cover 1 .

3. Remove the fuse with the fuse puller 2 .

4. If the fuse is open A , replace it with a new fuse B .

5. If a new fuse also opens, have the electrical system checked and repaired by a NISSAN dealer.

Extended storage switch (if so equipped)

Extended storage switch (if so equipped)

If any electrical equipment does not operate, remove the extended storage switch and check for an open fuse.

NOTE:
If the extended storage switch malfunctions, or if the fuse is open, it is not necessary to replace the switch. In this case, remove the extended storage switch and replace it with a new fuse of the same rating.

How to remove the extended storage switch:

1. To remove the extended storage switch, be sure the ignition switch is in the “OFF” or “LOCK” position.

2. Be sure the headlight switch is in the “OFF” position.

3. Remove the fuse box cover.

4. Pinch the storage switch and pull it in the direction illustrated.

Brakes
Battery replacement

See also:


Tires — general information
Tire Pressure Safety WARNING: • Improperly inflated tires are dangerous and can cause accidents. • Under-inflation increases tire flexing and can result in over-heating and tire failure. • Over-inflation reduces a tire’s ability t ...

Four wheel drive (4WD)
Engine power can be delivered to all front and rear wheels for maximum traction. Full-time 4WD is useful when extra traction is required on road, such as, when driving on slippery, muddy, wet, or snow-covered roads. These vehicles are not desig ...