Suzuki Grand Vitara: Fuel Gauge - Instrument Panel - Suzuki Grand Vitara Owner's ManualSuzuki Grand Vitara: Fuel Gauge

This gauge gives an approximate indication of the amount of fuel in the fuel
Fuel Gauge

This gauge gives an approximate indication of the amount of fuel in the fuel tank. “F” stands for full and “E” stands for empty. If the indicator gets off the graduation of “E” (not character “E”), refill the tank as soon as possible.

NOTE: The indicator moves a little depending on road conditions (for example, slope or curve) and driving conditions because of fuel moving in the tank.

If the low fuel warning light (1) comes on, fill the fuel tank immediately.

CAUTION: Avoid driving with an extremely low fuel level. Running out of fuel could cause the engine to misfire, damaging the catalytic converter.

NOTE: The activation point of the low fuel warning light (1) varies depending on road conditions (for example, slope or curve) and driving conditions because of fuel moving in the tank.

The mark (2) indicates that the fuel filler door is located on the right side of the vehicle.

    Tachometer
    Tachometer The tachometer indicates engine speed in revolutions per minute. CAUTION: Never drive with the engine speed indicator in the red zone or severe engine damage can result. ...

    Temperature Gauge
    Temperature Gauge When the ignition switch is in the “ON” position, this gauge indicates the engine coolant temperature. Under normal driving conditions, the indicator should stay within the ...

    See also:

    Tire Rotation and Required Services Every 12 000 km/ 7,500 mi
    Rotate the tires, if recommended for the vehicle, and perform the following services. See Tire Rotation on page 10‑57. ○ Check engine oil level and oil life percentage. If needed, chang ...

    Removing/attaching the washer fluid reservoir
    You must remove the washer fluid reservoir from the engine compartment before you can replace the bulbs in the left-hand headlamp. To detach: turn catch 2 counterclockwise. Swing washer flui ...

    Power-Up
    After switching the ignition key from OFF to either the ON or ACC position, or after a language change, you must wait at least fifteen seconds prior to using the system. ...