Toyota RAV4: Follow the correction procedures - If a warning light turns on or a warning buzzer sounds... - Essential information - When trouble arises - Toyota RAV4 Owner's ManualToyota RAV4: Follow the correction procedures

After taking the specified steps to correct the suspected problem, check that the warning light turns off.

*1:Driver's and front passenger’s seat belt warning buzzers

*1:Driver's and front passenger’s seat belt warning buzzers
The driver’s and front passenger’s seat belt warning buzzers sound to alert the driver and front passenger that his or her seat belt is not fastened. The buzzer sounds intermittently for 10 seconds after the vehicle has reached a speed of 12 mph (20 km/h). Then, if the seat belt is still unfastened, the buzzer will sound at a different tone for 20 more seconds. *2:Refer to the separate “Scheduled Maintenance Guide” or “Owner's Manual
Supplement” for the maintenance interval applicable to your vehicle.

    Have the vehicle inspected immediately
    Failing to investigate the cause of the following warnings may lead to the system operating abnormally and possibly cause an accident. Have the vehicle inspected by your Toyota dealer immediately. ...

    Follow the correction procedures. (vehicles with smart key system)
    After taking the specified steps to correct the suspected problem, check that the warning light turns off. *: If the engine does not start when the electronic key is inside the vehicle, the e ...

    See also:

    Front fog lamps
    Only vehicles with front fog lamps have the fog lamps function. WARNING If you suspect that driving conditions will be foggy, turn the light switch to before you start your journey. Otherwise ...

    Illuminated visor mirror (if equipped)
    Lift the mirror cover to turn on the visor mirror lamp. Slide-on-rod feature Rotate the visor towards the side window and extend it rearward for additional sunlight coverage. Note: To stow t ...

    When you do not tow a trailer
    - Remove the ball mount from the hitch receiver tube and insert the receiver cover onto the hitch receiver tube. - Place the dust cap over the four-pin connector of the hitch wire harness to ...