Jeep Liberty: Fog Lights — If Equipped - Lights - Understanding The Features Of Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Fog Lights — If Equipped

To activate the front fog lights, turn on the parking

To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out on the end of the multifunction lever.

Front Fog Light Control
Front Fog Light Control

NOTE: The front fog lights will only operate with the headlights on low beam. Selecting high beam headlights will turn off the front fog lights.

    Lights-On Reminder
    If the headlights or parking lights are on after the ignition is turned to the LOCK position, a chime will sound to alert the driver when the driver’s door is opened. ...

    Turn Signals
    Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. Turn Signal Control NOTE: ...

    See also:

    If the vehicle becomes stuck
    Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt, or snow. 1 Stop the engine. Set the parking brake and put the shift lever in P. 2 Remove the mud, sn ...

    Mist (for a single wipe)
    Mist (for a single wipe) For a single wipe of the wipers, pull the lever toward you. The wipers operate until you release the lever. ...

    Compass zone adjustment
    Compass calibration zones 1. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and ...