Volvo XC60: Extra high beam
1. Remove the headlight housing from the vehicle (see page 322).
2. Remove the cover over the bulbs (see page 323).
3. Disconnect the wiring connector from the bulb holder.
4. Remove the bulb holder from the headlight housing by pulling it straight out.
5. Insert a new bulb in the holder until it snaps in place. It can only be inserted in one way.
6. Press the bulb holder into position in the headlight housing.
7. Reconnect the wiring connector to the bulb holder.
8. Put the cover back into position and reinstall the headlight housing.
High beam, Halogen
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the cover over the bulbs (see
page 323).
3. Remove the bulb by turning it counterclockwise
and pulling it straight ...
Turn signals
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the bulb holder by turning it counterclockwise
and pulling it out of the headlight
housing.
3. Pull out the holder ...
See also:
Operating Information And Precautions
The Command-Trac II transfer case provides four positions:
• Two–wheel drive (2WD) high range
• Four-wheel drive (4WD LOCK) high range
• Four-wheel drive (4WD LOW) low range
• Neutra ...
If You Get Stuck
Avoid driving on soft sand, deep mud,
or other surfaces where you could
get stuck. If you do happen to get
stuck because of inclement weather
or other conditions, choose a safe
and appropria ...
Dynamic stability control (amber)
Dynamic stability control (amber)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started. If the lamp flashes while driving, the
DSC system is active. ...
