Jeep Liberty: EVIC Main Menu
To step to each main menu feature press and release the
MENU button once for each step. A step from the last
item in the list will cause the first item in the feature list
to be displayed. The following features are in the Main
menu:
• Compass, Outside Temperature, and Audio
Information/ECO display
• Average Fuel Economy
• Distance to Empty
• Tire Pressure Status display
• Elapsed Time
• EVIC Units Selection
• System Status
• Personal Settings
NOTE: For features in the EVIC that can be reset (Average Fuel Economy and Elapsed Time), the EVIC prompts a reset with a SELECT button graphic and the word RESET next to it.
When the SELECT button is pressed, the selected feature will reset and RESET ALL will display next to the SELECT button graphic. Pressing SELECT a second time will reset both Average Fuel Economy and Elapsed Time.
After three seconds without pressing SELECT, RESET ALL will return to RESET and only the selected feature will have been reset.
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The “Oil Change Required” message
will flash in the EVIC display for approximately 10 seconds
after a single chime has so ...
Compass Display / ECO (Fuel Saver Mode) — If Equipped
The compass readings indicate the direction
the vehicle is facing. Press and release the
COMPASS button to display one of eight
compass headings, the outside temperature,
and audio informati ...
See also:
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have
blown. If this happens, check and replace the fuses as necessary.
1 Vehicles without smart key system: Turn the engine switch
off ...
Driving when tired or sleepy
When you are tired or sleepy, your
reaction time will be delayed and
your perception, judgment and attentiveness
will be impaired. If you
drive when tired or sleepy, your,
your passenger ...
Removing/installing the headlamp cover
You must remove the headlamp cover in the engine compartment before you can replace
the bulbs in the headlamp.
To remove: press retaining clip 1 in the direction of the arrow.
Pull cover 2 f ...