Jeep Liberty: ESC Activation/Malfunction Indicator Light And ESC Off Indicator Light - Electronic Brake Control System - Starting And Operating - Jeep Liberty Owner's ManualJeep Liberty: ESC Activation/Malfunction Indicator Light And ESC Off Indicator Light

The “ESC Activation/Malfunction Indicator

The “ESC Activation/Malfunction Indicator Light” in the instrument cluster will come on when the ignition switch is turned to the ON position. It should go out with the engine running. If the “ESC Activation/Malfunction Indicator Light” comes on continuously with the engine running, a malfunction has been detected in the ESC system. If this light remains on after several ignition cycles, and the vehicle has been driven several miles (kilometers) at speeds greater than 30 mph (48 km/h), see your authorized dealer as soon as possible to have the problem diagnosed and corrected.

The “ESC Activation/Malfunction Indicator Light” (located in the instrument cluster) starts to flash as soon as the tires lose traction and the ESC system becomes active.

The “ESC Activation/Malfunction Indicator Light” also flashes when TCS is active. If the “ESC Activation/ Malfunction Indicator Light” begins to flash during acceleration, ease up on the accelerator and apply as little throttle as possible. Be sure to adapt your speed and driving to the prevailing road conditions.

NOTE:
• The “ESC Activation/Malfunction Indicator Light” and the “ESC OFF Indicator Light” come on momentarily each time the ignition switch is turned ON.

• Each time the ignition is turned ON, the ESC system will be ON even if it was turned off previously.

• The ESC system will make buzzing or clicking sounds when it is active. This is normal; the sounds will stop when ESC becomes inactive following the maneuver that caused the ESC activation.

The “ESC OFF Indicator Light” indicates the

The “ESC OFF Indicator Light” indicates the Electronic Stability Control (ESC) is off.

    Electronic Stability Control (ESC)
    This system enhances directional control and stability of the vehicle under various driving conditions. ESC corrects for oversteering or understeering of the vehicle by applying the brake of the ...

    See also:

    Removing the Spare Tire and Tools
    To access the spare tire and tools: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Lift the load floor up. Coin/Pierce Jack with One-Piece Wrench A. Extension B. Wheel Wrench C. Jack ...

    Replacing tail/stop/turn/backup lamp bulbs
    The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Make sure the ...

    Windshield Wiper Blades
    Clean the rubber edges of the wiper blades and the windshield periodically with a sponge or soft cloth and a mild non-abrasive cleaner or use the washer solvent. This will remove accumulations o ...