Jeep Liberty: Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded three-wire extension cord.
The engine block heater cord is found under the hood clipped to the heater line on the left side of the engine.
The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
After Starting
The idle speed will automatically decrease as the engine
warms up. ...
Automatic Transmission
CAUTION!
Damage to the transmission may occur if the following
precautions are not observed:
• Shift into PARK only after the vehicle has come to
a complete stop.
• Shift into or out of RE ...
See also:
Drink holder
Front Drink Holder
The front drink holder is located on the main
console .
WARNING:
o Use caution when using the drink holders.
A spilled beverage that is very hot
can injure you or your ...
Certification for wireless remote control (vehicles without smart keysystem)
For vehicles sold in the U.S.A.
FCC ID: HYQ12BDC
FCC ID: HYQ13BDC
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device ...
Preparation for using the Handsfree system
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
1. Press the OFF hook switch .
2. Select â ...
