Volvo XC60: Emergency Brake Assistance
EBA is designed to provide full brake effect immediately in the event of sudden, hard braking.
The system is activated by the speed with which the brake pedal is depressed.
When the EBA system is activated, the brake pedal will go down and pressure in the brake system immediately increases to the maximum level. Maintain full pressure on the brake pedal in order to utilize the system completely. EBA is automatically deactivated when the brake pedal is released.
NOTE
• When the EBA system is activated, the
brake pedal will go down and pressure
in the brake system immediately increases
to the maximum level. You must
maintain full pressure on the brake
pedal in order to utilize the system completely.
There will be no braking effect if
the pedal is released. EBA is automatically
deactivated when the brake pedal
is released.
• When the vehicle has been parked for
some time, the brake pedal may sink
more than usual when the engine is
started. This is normal and the pedal will
return to its usual position when it is
released.
Cleaning the brake discs
Coatings of dirt and water on the brake discs
may result in delayed brake function. This delay
is minimized by cleaning the brake linings.
Cleaning the brake pads is advisable in wet
weather, p ...
Symbols in the instrument panel
WARNING
If and
come on at the same time
and the brake level is below the MIN mark
in the reservoir or if a brake system-related
message is shown in the information display: DO NOT DRIVE. ...
See also:
Turning Confirmation Prompts ON/OFF
Turning confirmation prompts off will stop the system
from confirming your choices (e.g., the Uconnectâ„¢
Phone will not repeat a phone number before you dial it).
• Press the button to begin. ...
Reprogramming a single HomeLink® button
1. Press and hold the HomeLink® button
you wish to reprogram. DO NOT release
the button until step 4 has been completed.
2. When the HomeLink® indicator light
begins to flash slowly (after ap ...
Braking
If ABS intervenes when braking, you will feel a pulsing in the brake pedal.
If ABS intervenes: continue to depress the brake pedal with force until
the braking situation is over.
To make a fu ...