Jeep Liberty: Elapsed Time - Electronic Vehicle Information Center (EVIC) — If Equipped - Understanding Your Instrument Panel - Jeep Liberty Owner's ManualJeep Liberty: Elapsed Time

Shows the total elapsed time of travel since the last reset.

Elapsed time will increment when the ignition switch is in the RUN or START position.

Elapsed time is displayed as follows:
hours:minutes:seconds

Elapsed time can be reset by pressing and holding the SELECT button (as prompted in the EVIC display). Upon reset all digits will change to zeros and time will start incrementing again if the ignition switch is in RUN or START.

    Tire Psi
    Press and release the MENU button until Tire PSI is displayed. Tire pressure information is displayed as follows: • If tire pressure is OK for all tires, TIRE and a vehicle graphic are display ...

    EVIC Units Selection (Units In Display)
    Displays the units used for the Outside Temperature, Average Fuel Economy, Distance to Empty and Tire Pressure features. Press and release the SELECT button to toggle units between U.S. and METR ...

    See also:

    Doors Liftgate
    WARNING Exhaust gases can enter the vehicle if it is driven with the liftgate or trunk/hatch open, or with any objects that pass through the seal between the body and the trunk/hatch or liftgate. ...

    Flash-to-Pass
    The flash&-to&-pass feature works with the low beams or Daytime Running Lamps (DRL) on or off. To flash the high beams, pull the turn signal/lane change lever all the way toward you, then ...

    Installing a Child Seat
    After selecting a proper child seat and a good place to install the seat, there are three main steps in installing the seat: 1. Properly secure the child seat to the vehicle. All child seats ...