Nissan Rogue: Compass (if so equipped)
When the ignition switch is turned to the ON position, the compass display B will indicate the direction of the vehicle’s heading.
If the display reads “C”, calibrate the compass by driving the vehicle in 3 complete circles at less than 5 MPH (8 km/h). You can also calibrate the compass by driving your vehicle on your everyday route. The compass will be calibrated once it has tracked 3 complete circles.
To turn on and off the compass manually, push
the 
switch
A while the ignition switch is in
the ON position.
Instrument brightness control
The instrument brightness control operates
when the headlight switch is in the or
position.
Turn the control A to adjust the brightness of
the meter panel and the instrument panel lights.
...
Zone variation change procedure
Zone map
The difference between magnetic north and
geographical north is known as variance. In
some areas, this difference can sometimes be
great enough to cause false compass readings.
Foll ...
See also:
Setting a speed
Use the or
buttons set the vehicle's current
speed. The set speed is shown in the display.
NOTE
Cruise control cannot be engaged at
speeds below 20 mph (30 km/h). ...
Stopping the engine
The ignition switch should be turned off
only when the vehicle is stopped and the
engine is idling.
Do not stop the engine when the
vehicle is moving. This will cause
loss of power to the ...
Connectable iPod® models Type C audio:
Type D audio:
Do not connect an iPod® other than
the previously stated models. Doing
so may result in a malfunction or,
depending on conditions, cause a
fire.
NOTE
- iPod® is a r ...
