Ford Escape: Clear MyKey
To reset all MyKeys as admin keys do the following:
1. Turn the vehicle on using the admin key.
2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.
3. Press and release the RESET button. HOLD RESET TO CONFIRM
CLEAR is displayed.
4. Press and hold the RESET button for two seconds until ALL MYKEYS
CLEARED is displayed.
Programming MyKey Optional Settings
Turn the ignition on using an admin key. To program the optional
settings, use the message center buttons to do the following:
1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed.
2. Press ...
Check MyKey System Status
The vehicle’s message center system check will provide the status of the
following MyKey parameters:
• MYKEY MILES — This odometer only tracks mileage when a MyKey
is used. If mileage does ...
See also:
Express-open/Express-close
Press and release the front or rear of the driver side switch to express-open
or express-close the sunroof. ...
Adjusting the set speed
After a speed has been set, it can be increased
or decreased by using the or
buttons.
1. Press and hold down or
until the
vehicle reaches the desired speed.
> This will become the set ...
Forward-facing child restraint installation using
LATCH
Refer to all Warnings and Cautions in the “Child
safety” and “Child restraints” sections before
installing a child restraint.
Follow these steps to install a forward-facing
child restra ...