Range Rover Evoque: Bulb specification chart
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Technical specifications / Bulb specification chart
Before attempting to replace
a bulb,
ensure that both the affected lamp and
the vehicle's ignition, are turned off. If
the circuit remains live, a short circuit
can occur which may damage the
vehicle's electrical system.
Note: LED bulbs can be replaced only by a Land Rover Dealer/Authorised Repairer.
READ NEXT:
Smart key system transmitters
1. Steering column backup transmitter.
2. Front cockpit transmitters.
3. Front exterior door handle transmitters.
4. Roof keyless receiver.
5. Floor console front transmitter.
6. Rear exterior
SEE MORE:
Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is removed for access only.
8. Torque: 0.6 Nm
9.
10. Torque: 1 Nm
11.
Installation
1. To install,
Transmission Vehicles With: M66 6-Speed
Manual Transmission AWD - Removal
Removal
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
General Equipment
Transmission jack
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. Disconnect the battery
© 2011-2024 Copyright www.rrevoque.org
