Volvo XC60: Brake system
The brake system is a hydraulic system consisting of two separate brake circuits. If a problem should occur in one of these circuits, it is still possible to stop the vehicle with the other brake circuit.
If the brake pedal must be depressed farther than normal and requires greater foot pressure, the stopping distance will be longer.
A warning light in the instrument panel will light up to warn the driver that a fault has occurred.
If this light comes on while driving or braking, stop immediately and check the brake fluid level in the reservoir.
NOTE
Press the brake pedal hard and maintain
pressure on the pedal – do not pump the
brakes.
WARNING
If the fluid level is below the MIN mark in the
reservoir or if a brake system message is
shown in the information display: DO NOT
DRIVE. Have the vehicle towed to a trained
and qualified Volvo service technician and
have the brake system inspected.
Brakes
...
Brake pad inspection
On vehicles equipped with a jack*, the condition
of the brake pads can be checked by raising
the vehicle (see page 306 for information
about using the jack and removing a wheel)
and performing ...
See also:
Four-wheel drive lock switch (4WD models)
Four-wheel drive lock mode can be used when a large amount of
drive power needs to be applied to all the wheels, such as when the
vehicle gets stuck in mud and you need to free it.
Press the swit ...
Activating/deactivating
The evaporator is ventilated when the airconditioning system is operated. The
blower is activated automatically approximately one hour after the vehicle has been
locked. The blower operates on ...
Dashboard fuse box
Do not use a pointed object such as a screwdriver to open the
cover in the dashboard. You could damage the dashboard or the cover.
To open: pull out cover 1 slightly at the bottom in the
...
