Volvo XC60: Automatic opening - Power tailgate - Loading - During your trip - Volvo XC60 Owner's ManualVolvo XC60: Automatic opening

The power tailgate can be opened automatically in the three ways:

• By pressing and holding the button button on the lighting panel until the tailgate begins to open.

• By pressing and holding the button button on the remote key until the tailgate begins to open.

• By pressing the rubber-covered button under the outer handle on the tailgate.

The taillights illuminate automatically when the automatic open function is used.

CAUTION Be sure that there is adequate space above and behind the vehicle before opening the tailgate automatically.
The vehicle should not be driven or moved with the tailgate in the open position. However, if the vehicle is moved with the tailgate in the open position, the automatic closing function will be inoperative until one of the following occurs:
• The tailgate is closed manually
• The ignition is switched off and the key is removed for approximately 10 minutes (the tailgate will function again after restart).

NOTE
If the tailgate has been opened and closed continuously for more than 60 seconds, the automatic function will be deactivated to avoid overloading the electrical system. The automatic function can be used again after approximately 10 minutes.
If the vehicle's battery has been discharged or disconnected, the tailgate must be opened and closed once manually to reset the system.

    Power tailgate
    Power tailgate closing button ...

    Automatic closing
    The power tailgate can be closed by pressing the button on the tailgate (see the illustration) or by pressing it down. NOTE If the tailgate is pressed down e.g., by the weight of snow or st ...

    See also:

    If the battery is discharged
    The following procedures may be used to start the engine if the vehicle's battery is discharged. You can call your Toyota dealer or qualified repair shop. If you have a set of jumper (or booster) c ...

    Category selection
    Type A, B and C audio To activate the category search mode, press the “PTY/CAT” button. To deactivate the category search mode, press the “PTY/CAT” button again. When in the category ...

    Reset
    • press the button. • After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”. This will delete all phone pairing, phone book entries, and other settings in ...