Mercedes-Benz GLK-Class: ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the alarm system is armed and you open:
- a door
- the vehicle with the mechanical key
- the tailgate
- the hood
The alarm is not switched off, even if you close the open door that has triggered it, for example.
If the alarm stays on for more than 30 seconds, the emergency call system mbrace
(USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance
Center automatically. The emergency call system initiates the call provided that:
- you have subscribed to the mbrace/ TELE AID service.
- the mbrace/TELE AID service has been activated properly.
- the required mobile phone, power supply and GPS are available.
- To arm: lock the vehicle with the SmartKey or KEYLESS-GO. Indicator lamp 1 flashes. The alarm system is armed after approximately 15 seconds.
- To deactivate: unlock the vehicle with the SmartKey or KEYLESS-GO.
- To stop the alarm using the SmartKey: insert the SmartKey into the ignition lock. The alarm is switched off.
or
- Press the
or
button on the SmartKey.
The alarm is switched off.
- To stop the alarm using KEYLESS-GO:
grasp the outside door handle. The SmartKey must be outside the vehicle. The alarm is switched off.
or
- Press the Start/Stop button on the dashboard. The SmartKey must be inside
the vehicle.
The alarm is switched off.
Immobilizer
The immobilizer prevents your vehicle from being started without the correct
SmartKey.
When leaving the vehicle, always take the SmartKey with you and lock the vehicle.
The engine can be started ...
Opening/closing
...
See also:
Rear Vision Camera Location
The camera is located above the license plate.
The area displayed by the camera is limited.
It does not display objects that are close to either corner or under the bumper
and can vary depending ...
Using white spirit
Stubborn stains such as tar spots and grease
may require the use of white spirt. After use,
ensure the area is washed immediately with
warm soapy water to remove all traces of the
spirit. ...
Changing
WARNING
Connect and disconnect the positive and
negative cables in the correct sequence. ...