Volvo XC60: Tire sealing system–temporarily repairing a flat tire
Tire sealing system–temporarily repairing a flat tire
Temporarily repairing a flat tire is done in two stages:
• Stage 1: The hole is sealed by pumping sealing compound into the tire. The car is then driven a short distance to distribute the sealing compound in the tire.
NOTE
Do not remove any foreign objects (nails,
etc.) from the tire before using the sealing
system.
• Stage 2: The tire’s inflation pressure is checked and adjusted if necessary.
WARNING
• Never leave the tire sealing system
unattended when it is operating.
• Keep the tire sealing system away from
children.
• Be sure the vehicle is parked safely off
the road and away from moving traffic.
• Apply the parking brake.
- Stage 1: Sealing the hole
- Stage 2: Checking inflation pressure
- Replacing the sealing compound container
Tire sealing system–overview
1 Speed limit sticker
2 On/Off switch
3 Electrical wire
4 Bottle holder (orange cover)
5 Protective hose cover
6 Air release knob
7 Hose
8 Bottle with sealing compound
9 Air pressure gauge
...
Stage 1: Sealing the hole
1. Open the cover on the tire sealing kit.
2. Peel off the speed limit sticker and affix it
to the steering wheel hub where it will be
clearly visible to the driver.
3. Ensure that the on/off sw ...
See also:
Replacing fog lamp bulbs (if equipped)
1. Make sure the fog lamp switch is
in the off position.
2. From underneath the vehicle,
carefully disconnect the electrical
connector from the bulb.
3. Remove the bulb from the lamp
assembly by ...
Repeat play
Press (RPT).
To cancel, press (RPT) again. ...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
If the level is below the bottom of the fill plug hole, located on the transfer
case, the vehicle will need some lubricant ad ...
