GMC Terrain: Tire and Loading Information Label - Vehicle Load Limits - Driving Information - Driving and Operating - GMC Terrain Owner's ManualGMC Terrain: Tire and Loading Information Label

Label Example

Label Example

A vehicle specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar). With the driver's door open, you will find the label attached near the door lock post. The Tire and Loading Information label shows the number of occupant seating positions (A), and the maximum vehicle capacity weight (B) in kilograms and pounds.

The Tire and Loading Information label also shows the tire size of the original equipment tires (C) and the recommended cold tire inflation pressures (D). For more information on tires and inflation see Tires on page 10‑44 and Tire Pressure on page 10‑51.

There is also important loading information on the Certification label. It tells you the Gross Vehicle Weight Rating (GVWR) and the Gross Axle Weight Rating (GAWR) for the front and rear axle. See “Certification Label” later in this section.

    Vehicle Load Limits
    It is very important to know how much weight the vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo and all nonfactory&-instal ...

    Steps for Determining Correct Load Limit
    1. Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs” on your vehicle's placard. 2. Determine the combined weight of the driver and pass ...

    See also:

    ECO gauge (models with type A combination meter)
    The unit displayed varies depending on the model. The ECO gauge shows the difference between the average rate of fuel consumption since the trip meter was last reset and the current rate ...

    Introduction
    City Safety™1 is a support system designed to help the driver avoid low speed collisions when driving in slow-moving, stop-and-go traffic. City Safety™ is not active if your vehicle’s spe ...

    Reprogramming a Single HomeLink Button
    To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. DO NOT release the button. 2. The indicator light ...