Range Rover Evoque: Rolling re-start
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine / Rolling re-start
If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated.
Automatic transmission - select neutral (N) and then press the engine START/STOP button.
When the engine re-starts, select transmission position D.
Manual transmission - depress the clutch and then press the engine START/STOP button.
When the engine re-starts, select an appropriate forward gear.
READ NEXT:
Keyless start backup
If the vehicle has been unlocked using the
emergency key blade or the Smart Key is not
detected by the vehicle, it will be necessary to
use the keyless start backup to disarm the
alarm and start t
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst
Conditions preventing automatic engine stop
The engine will not automatically stop if:<>
- the external temperature is below approximately 0°C (32°F)
- the external temperature is above approximately40°C (104°F)
- engine has not re
SEE MORE:
Component Description
Parking Aid Module
The parking aid module is located on the LH side of the luggage compartment,
behind the 'C' pillar trim panel.
The parking aid module has three connectors which provide for power, ground and
CAN bus connections, front parking aid
sensors and rear parking aid sensors.
The high
Inner Back Panel Assembly
Removal
NOTES:
The inner back panel assembly is manufactured from mild steel.
The panel is serviced less its weld studs.
The new service panel is not fully spot welded when supplied.
It is necessary to remove a section of one rear lamp mounting panel to enable
removal and installation of the inn
© 2011-2024 Copyright www.rrevoque.org
