Range Rover Evoque: Rear lamp bulbs

1. Remove the two fixings.

1. Remove the two fixings.

2. Direction indicator.

3. Reversing lamp

Turn the relevant bulb holder counter clockwise and pull to remove from the lamp unit. Grip the holder then press the bulb into the holder and turn counter clockwise to release the bulb. Pull the bulb up to remove.

READ NEXT:

 Rear fog lamp

Access to the rear fog lamp requires special tools and should be undertaken only by a qualified technician. If in doubt, consult your Land Rover Dealer/Authorised Repairer.

 Cleaning the exterior

Remove any heavy deposits of mud and dirt with a hose before washing the vehicle. Never aim a hose water jet directly at the engine air intake, heater air intakes, body seals or at any compone

 Using white spirit

Stubborn stains such as tar spots and grease may require the use of white spirt. After use, ensure the area is washed immediately with warm soapy water to remove all traces of the spirit.

SEE MORE:

 Blower Motor RHD AWD/RHD FWD, RHD

Special Tool(s) 412-140 Remover/Installer, Blower Motor Removal NOTES: Removal steps in this procedure may contain installation details. Some variation in the illustrations may occur, but the essential information is always correct. All vehicles 1. NOTE: The recirculation blend door must be closed

 Manual Transmission/Transaxle and Clutch - General Information

Lubricant Capacities General Specification Torque Specifications Clutch System Bleeding NOTE: Some variation in the illustrations may occur, but the essential information is always correct. All vehicles 1. Check that all the clutch line connections are tight and that there are no signs of leaks

© 2011-2024 Copyright www.rrevoque.org