Nissan Rogue: Initialization - Using the system - Bluetooth® Hands-Free Phone System (if so equipped) - Center display, heater, air conditioner, audio, phone and voice recognition systems - Nissan Rogue Owner's ManualNissan Rogue: Initialization

When the ignition switch is placed in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. If the button is pushed before the initialization completes, button is pushed before the initialization completes, the system will accept any command.

    Using the system
    The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® Hands- Free Phone System. If the vehicle is in motion, some commands may not be available so full attention ma ...

    Operating tips
    To get the best performance out of the NISSAN Voice Recognition system, observe the following: - Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surroundi ...

    See also:

    Uniform Tire Quality Grading
    Quality grading information ALL PASSENGER VEHICLE TIRES MUST CONFORM TO FEDERAL SAFETY REQUIREMENTS IN ADDITION TO THESE GRADES Quality grades can be found, where applicable, on the tire sid ...

    Language Selection
    To change the language that the Uconnect™ Phone is using: • Press the button to begin. • After the “Ready” prompt and the following beep, say the name of the language you wish to swit ...

    Back–Up Lamp
    Removal of the lamp assembly is not required to replace the back-up lamp bulb. To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the interior trim acces ...