Range Rover Evoque: Flat spots due to long term parking

In order to minimise flat spotting, the tyre pressures can be increased to the maximum as stated on the tyre sidewall, for the period when the vehicle is stationary. Tyres must be returned to the specified running pressures before driving.

READ NEXT:

 Age degradation

Tyres degrade over time due to the effects of ultraviolet light, extreme temperatures, high loads, and environmental conditions. It is recommended that tyres are replaced at least every six years,

 Winter tyres

In many countries legislation exists that requires the use of winter tyres during specified periods of the year. M+S tyres have a recognised level of winter performance and need not be replaced.

 Using traction devices

Only use traction devices in heavy snow conditions, on hard road surfaces. Dynamic Stability Control (DSC) must be switched off when using traction devices. Never exceed 50 km/h (30 mph) when

SEE MORE:

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

 Tyre pressure compensation for low ambient temperature changes

A colder ambient local temperature will reduce pressure within the tyre. An effect is to decrease sidewall height and to increase tyre shoulder wear with the potential for tyre failure. Vehicle dynamics could also be adversely affected. Tyre pressures can be adjusted to compensate before the

© 2011-2024 Copyright www.rrevoque.org