GMC Terrain: Cruise Control Messages - Vehicle Messages - Instruments and Controls - GMC Terrain Owner's ManualGMC Terrain: Cruise Control Messages

APPLY BRAKE BEFORE CRUISE

If this message displays when attempting to activate cruise control, apply the brake pedal and try again.

CRUISE SET TO XXX

This message displays when the cruise control is set and shows the speed it was set to. See Cruise Control on page 9‑38 for more information.

    Compass Messages
    CAL This message is displayed when the compass needs to be calibrated. See Compass on page 5‑5. – – – Three dashes will be displayed if the compass needs service. See your dealer fo ...

    Door Ajar Messages
    DOOR OPEN A door open symbol will be displayed on the DIC showing which door is open. If the vehicle has been shifted out of P (Park), a DOOR OPEN message will also be displayed. Close the door c ...

    See also:

    Re-installing the wheel
    1. Clean the contact surfaces on the wheel and hub. 2. Lift the wheel and place it on the hub. Tighten the lug nuts 3. Install the wheel nuts and tighten handtight. Using the lug wrench, tight ...

    Lubrication system
    *: The engine oil capacity is a reference quantity to be used when exchanging. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick. ■ Engine ...

    Temperature Grades
    The temperature grades are A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat, when tested under controlled conditions on ...