Toyota RAV4: Automatic transmission - Driving procedures - When driving - Toyota RAV4 Owner's ManualToyota RAV4: Automatic transmission

Select a shift position appropriate for the driving conditions.

■ Shifting the shift lever

4-speed models

5-speed models

5-speed models

Vehicles without smart key system:

Vehicles without smart key system:

While the engine switch is in the “ON” position, depress the brake pedal and move the shift lever. Vehicles with smart key system:

While the “ENGINE START STOP” switch is in IGNITION ON mode, depress the brake pedal and move the shift lever.

■ Shift position uses

*: Shifting to the D position allows the system to select a gear suitable

*: Shifting to the D position allows the system to select a gear suitable for the driving conditions. Setting the shift lever to the D position is recommended for normal driving.

■Downshifting restrictions

The shift lever cannot be downshifted if the following speeds are exceeded. 4-speed models (2WD)

mph (km/h)

4-speed models (4WD)

4-speed models (4WD)

mph (km/h)

5-speed models

5-speed models

mph (km/h)

■When driving with cruise control activated

■When driving with cruise control activated

4-speed models

Even when performing the following actions with the intent of enabling engine braking, engine braking will not activate while downshifting to 3 because cruise control will not be canceled.

5-speed models

Even when performing the following actions with the intent of enabling engine braking, engine braking will not activate while downshifting to 4 because cruise control will not be canceled.

■If the shift lever cannot be shifted from P

    Engine (ignition) switch (vehicles without smart key system)
    ■ Starting the engine 1 Check that the parking brake is set. 2 Check that the shift lever is set in P. 3 Sit in the driver’s seat and firmly depress the brake pedal. 4 Turn the engine swit ...

    Turn signal lever
    1 Right turn 2 Left turn 3 Move and hold the lever partway to signal a lane change. The right hand signal will flash until you release the lever. 4 Move and hold the lever partway to signal ...

    See also:

    Connecting a device to the A/V-AUX socket
    The A/V-AUX socket is located under the center armrest in the tunnel console 1. Connect the device's video cable to the yellow connector. 2. Connect the left audio cable to the white connector ...

    Automatic opening
    The power tailgate can be opened automatically in the three ways: • By pressing and holding the button on the lighting panel until the tailgate begins to open. • By pressing and holding ...

    Storing a Flat or Spare Tire and Tools
    WARNING Storing a jack, a tire, or other equipment in the passenger compartment of the vehicle could cause injury. In a sudden stop or collision, loose equipment could strike someone. Store all t ...